Batribike 20 Specifications download pdf (Page 19)

After 3,000 miles (5,000 km) (or YEARLY)

● Hub motor and general inspection

We recommend you arrange to have a thorough inspection of

your tricycle by a BATRIBIKE dealer. This includes opening up

the hub motor to inspect and lubricate the gears.

Tyre Pressures

The tyres should be pumped up to within the range stated on the sidewall.

This should be regularly checked as running with the correct pressures

will ensure maximum range from the battery.

Repairing a punctured tyre

If you have a punctured tyre, we recommend that you get a specialist to carry

out the repairs. You can always of course consult a specialist and carry out the

repairs on your own if you are confident that you have the necessary skills.

As there are no electronic components on the rear wheels, their removal follows

standard procedures as with normal bicycles.

Removing the Front Wheel

If you need to remove the front wheel, for

example, to replace the front tyre, then the motor

can be unplugged to aid disassembly. The plug

is located on the left side of the forks as shown,

(Left).

Take care when re-assembling the plug to

ensure that the two arrows are aligned correctly.

Remember to ensure that the cable is suitably secured to the tricycle fork upon

re-assembly.

Be mindful of the tightening assembly sequence of washers, nuts and spacers.

Battery Fuse

If the battery will not operate or charge correctly, firstly check the battery fuse

(rated 30A) located on the side of the battery beneath the screw cover. Use a

large flat bladed screwdriver or a small coin to remove the cover.

MOTOR

PLUG

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

Batribike 20 Specifications Page 19